Couldn't find any decent CNC drawings so going to have to make my own, last of insulation gone in and on with templates and mock up, should be able to work out all dimensions and machine up next week, will still need some scribe work but it's coming on.
Coming together, looking good, should be ready next week for the real thing. Its what Sundays were made for.
Plenty storage under rock & roll bed and fitting a overhead at the back and a separate free standing unit as you open the side door for plates, pans etc with preparation area on top. This will be where some people install a buddy seat
Opted for material this time for comfort for the bed. Interior ready next week, fingers crossed I worked it all out right.
Delivery arrived back from CNC and the dry fit has gone well with only a few minor adjustments, and the whole set-up is incredibly light, onto staining & finishing this weekend then it's the install and can move onto the electrics, after much deliberation I have decided to install MPPT for the solar power while at it.....watch this space.
Finally getting there, am installing the Heat Source 2000 this weekend and have a mess with the EMPI shifter, the Shunt is now in and is great piece of kit together with the IPP2 Victron Blue tooth battery charger which is an excellent, would have stayed with Renogy but they currently do not offer the same unless you want the 50A DC-DC. I installed a gas hob and sink in my last Bus but never used as just plugged in a hot plate a cooked outside so currently not sure. Due to the electrical cabinet I designed you lose some of the back window, last time is just blacked out but this time fancied something different and have had few comments, basically wanted it to look like an old tool/part shelf and think it works well.
